OM_CHAPTER 2 WITH GESTURE SENSOR +TRAVEL CASE
This should be your last power supply!
Enough machines to plug-in, enough power (too much, maybe), enough memories, enough love inside and all this, in a small size and unique power supply.
Our OM power supply has the following features:
- 4 Amps RMS, 7 Amps peak.
- 1,2 – 16 Volts.
- Two outputs (you can plug two machines).
- 3 memories per machine, 6 memories in total. In every memory you can save a voltage and the footswitch mode. Every little circle on the bottom of the screen is a memory.
- Ranurated encoder allows to increase 0.1V per step. The encoder has also a push button to turn ON and OFF the machine output.
- 2 Footswitch modes. A normal mode and special mode that allows you to use your plates footswitch as an interrupter (once pressed you can release your feet and it keeps going until you press again).
- Motion sensor to turn on and off your machine avoiding cross contamination. It is placed on the left side panel of the power supply. Check the pictures. You will be able to Turn-on/off, Change your preset/memory and swap your machine just with the movement detection
- 4 ways to turn on and off your machine. (Footswitch mode 1, Footswitch mode 2, button on knob, motion sensor)
- Chronometer with hours, minutes and seconds.
- 4 neodymium magnets (20 Kg of strength).
- High grade aluminum casing.
- Travel case included.
- High bright 1,3′ screen with plastic protector.
- best quality electronic components.
- Intuitive interface, Easy to use.